Разширяване на следата (фланци) H&R TRAK+® Wheel Spacers сребрист 3034650 за Peugeot 106 (1A,1C) 1.4 - 69 коня бензин

За автомобил:

Peugeot 106 (1A,1C) 1.4

Двигател:

69 коня - 51 kW - бензин

Парт номер:

3034650

Производител:

долен преден мост с граница на запресоване [mm]:

-20 mm

долен заден мост с граница на запресоване [mm]:

-20 mm

мярка на резбата:

M12x1,25

разширение на следата [mm]/ос:

30 mm

дебелина [mm]:

15 mm

брой на дупките:

4

Кръг на дупките Ø [mm]:

108 mm

центриращ диаметър [mm]:

65 mm

цвят:

сребрист

вид регистрация:

с експертиза от TÜV®

да се спазван инструкциите за монтаж:

обща информация:

For all cars with 4-hole wheel.

обща информация:

Please note additional information and vehicle-specific technical notes!

технически данни:

DR = The wheel spacer should be fitted between the wheel and the axial hub using longer bolts not supplied - please order separately. When ordering the longer bolts please state which cone type you require (i.e. taper, round, loose round or flat) and the required extra length. All screws for the DR systems have to be orderded separately.

технически данни:

All DR-Systems require longer wheel-bolts. These have to be ordered separately. When ordering wheel-bolts please follow these guidelines: If possible name the type of the wheel when ordering. New bolts must be longer than the original ones by half of the total Track-widening. For example: With a 30 mm DR-kit you will require bolts that are 15 mm longer than the original bolts. The bold-head must be identical to the existing bolt: Taper 60° Round-head for M12/d24 mm, for M14/d28 mm Round-head for M12/d26 mm (e.g. OE VAG-wheels) Flat-head with disc for CITROEN/PEUGEOT-vehicles M12x1,25 Flat-head for PORSCHE-original-wheels M14x1,5 Safety Guidelines (No. of turns for wheel screws) M12x1,5 = 6,5 turns = approx. 10 mm of load bearing shaft length M12x1,25 = 8,0 turns = approx. 10 mm of load bearing shaft length M12x1,75 = 6,5 turns = approx. 12 mm of load bearing shaft length M14x1,5 = 7,5 turns = approx. 12 mm of load bearing shaft length 1/2"UNF = 8,0 turns = approx. 11 mm of load bearing shaft length Please ensure that the wheel screws do not damage any part of the brake system (ABS sensors etc.) Turn the wheel first by hand and check clearance on the inside (max. tolerance for some vehicles is only 2 mm (RA Mercedes).

обща информация:

The original wheel screw which sticks out of the inner side of the wheel needs to have a permanent thread and it´s length has to be smaller than the thickness of the spacer.

обща информация:

Note 18b: For the usage of these spacers certain specific technical requierements need to be fulfilled! Please check product information document TRAK_HINWEISE.pdf note 18b!

технически данни:

Not usable with steel-rims!